4. With the coolant surge tank pressure cap off,
start the engine and let it run until you can
feel the upper radiator hose getting hot. Watch
out for the engine cooling fan.
By this time, the coolant level inside the
coolant surge tank may be lower. If the level
is lower, add more of the proper DEX-COOL
®
coolant mixture to the coolant surge tank
until the level reaches the COLD FILL line.
5. Then replace the pressure cap. Be sure the
pressure cap is hand-tight.
Check the level in the surge tank when the cooling
system has cooled down. If the coolant is not
at the proper level, repeat Steps 1 through 3 and
reinstall the pressure cap. If the coolant still is
not at the proper level when the system cools
down again, see your retailer.
Windshield Washer Fluid
What to Use
When you need windshield or rear window
washer fluid, be sure to read the manufacturer’s
instructions before use. If you will be operating
your vehicle in an area where the temperature may
fall below freezing, use a fluid that has sufficient
protection against freezing.
341
To Next Page
Loading...
Need help?
General
