Electrical
connections
Boiler
installation
Assembly •
Hook the upper part of the
boiler to the support bracket.
230 V power supply
Connect the boiler
power cable to the
single-phase 230 V mains
+ earth.
23
• Let the boiler go down.
Before any operation,
it is necessary to carry out a
thorough cleaning of the pipes,
with a suitable product, in order
to eliminate metal residues
from processing and welding,
oil and various greases that
could be present and
which, reaching the boiler
could affect its
functioning.
According to current standards,
this connection must
be made by means of a
bipolar switch with a contact
opening of at least
3 mm.
• Position the gaskets.
NB: the use of solvents
could damage the circuit.
Attention: the power
cable integrated in the appliance
is a special cable.
Screw the various connections
between the boiler and the wall.
• Remember to connect the blue
extension to the filling
tap as shown in the figure.
If it is necessary to replace it,
contact an Authorized
Assistance Centre.
Machine Translated by Google
To Next Page
Loading...
