INSTALLATION
For the Themaclassic AS :
1/ remove the plastic
protection from the
connector located on the
electronic board.
24
Room thermostat
Room
thermostat
2/ Connect the wires
of the thermostat and the
boiler as shown in the figure.
Room thermostat
Connect the thermostat wires
as shown in the figure.
Important : the connector is
used to connect a
thermostat .
If the room thermostat
has not been used, leave
the bridge between the two
points of the terminal.
Under no circumstances
should it receive 230V
mains power.
Kettle
Electrical
connections
2
1
Machine Translated by Google
To Next Page
Loading...
