My boiler has
stopped, the red light and
the pressure indicator are
flashing!
After bleeding, check the
pressure and restore it if
necessary. If the anomaly
persists, contact the assistance
centre.
If the filling has to be
done too frequently, there
could be a leak in the system.
good evacuation of burnt gases :
this leads to the stagnation
of harmful gases.
There may be air in the pipes.
proceed to bleed the radiators
by opening the appropriate
cock.
The more water flow
drawn, the less hot the
water is. In this case, it is
necessary to reduce
the flow rate at the tap until
the desired temperature is
reached.
I hear the sound of water
inside the radiators.
The task of the room
thermostat is not to
operate the boiler
when the external conditions,
such as a sunny day,
allow the desired
temperature to be maintained
in the room.
Indeed, the water temperature
depends on the required
flow rate.
When I open the hot water
tap fully it seems to me that
the water is less hot !
Since I installed the room
thermostat, the radiators
sometimes stay cold
for a long time.
The obstruction would prevent
The arrival of hot water
depends on the quantity
of cold water contained in the
pipes. If the bathroom
is 10 meters from your
boiler, the seconds needed for
the heat to arrive will
seem endless...!
It is essential for the
operation of your boiler.
Before the hot water
reaches the bathroom
I have to wait a long time !
ABSOLUTELY NOT!
It is extremely dangerous!
8
It is therefore
necessary to restore the
pressure by opening
the appropriate blue tap
located under the boiler
until the pressure of 0.8
bar is read on the display.
The boiler has stopped because
it has detected a lack
of water in the system.
I would like to close the
ventilation opening
where the boiler is
installed because cold
air enters. I can do it?
In this case consult your
installer.
USER
ÿ
0,5
Your
questions…
bar
Machine Translated by Google
To Next Page
Loading...
