Scag Power Equipment Turf Tiger STT52V-26CH-EFI User Manual (English)

Questions and Answers:

S
Samantha HolmesAug 10, 2025
Why is my Scag Power Equipment Turf Tiger STT52V-26CH-EFI Lawn Mower leaving streaks of uncut grass in the cutting path?
- R
  rebecca56Aug 10, 2025
  If your Scag Power Equipment Lawn Mower is leaving strips of uncut grass in the cutting path, several factors could be at play. The blades might be dull or worn, or perhaps they were sharpened incorrectly, so sharpen the blades. Ensure the engine is running at full RPM. Slipping belts could also be the culprit, so adjust the belt tension. Grass accumulation under the deck can cause this issue; therefore, clean the underside of the deck. Avoid mowing wet grass and slow down your ground speed. Bent blades can also cause this problem, so replace the blades.
L
Laura JacksonAug 15, 2025
What to do if my Scag Power Equipment Turf Tiger STT52V-26CH-EFI Lawn Mower leaves stringers of uncut grass?
- M
  Malik KellyAug 15, 2025
  If your Scag Power Equipment Lawn Mower occasionally leaves blades of uncut grass, also known as stringers, it could be due to several reasons. Ensure the engine is running at full RPM. Adjust your ground speed to suit the conditions. Avoid cutting wet grass; wait until it has dried out. Sharpen the blades. Clean the underside of the deck to remove any grass accumulation. Finally, adjust the belt tension to prevent slipping.
K
Kimberly NunezAug 20, 2025
How to fix an uneven cut on flat ground with my Scag Power Equipment Turf Tiger STT52V-26CH-EFI?
- D
  Darrell MitchellAug 20, 2025
  If your Scag Power Equipment Lawn Mower is producing an uneven cut on flat ground, resulting in a wavy, high-low appearance, scalloped cut, or rough contour, consider these potential causes. If the lift is worn from the blade, replace the blade. Ensure the blade is mounted correctly with the cutting edge toward the ground. Clean the underside of the deck to remove any grass accumulation. Adjust the deck pitch and level. If the deck is mounted improperly or the spindle area is bent, consult your authorized SCAG dealer. Also, ensure that you sharpen the blade.
J
Janet ConnerAug 26, 2025
Why does my Scag Power Equipment Turf Tiger STT52V-26CH-EFI Lawn Mower leave a sloping ridge across the cutting path?
- A
  Amy GregoryAug 26, 2025
  If your Scag Power Equipment Lawn Mower is leaving a sloping ridge across the width of the cutting path, check and adjust the tire pressure to ensure it is equal on all tires. Also, ensure the wheels are even. If the deck is mounted incorrectly, consult your authorized SCAG dealer. Check if the deck is level side-to-side and correct if necessary.
J
Jessica KramerAug 29, 2025
Why does my Scag Power Equipment Turf Tiger STT52V-26CH-EFI Lawn Mower leave strips of uncut grass between cutting paths?
- A
  April WangAug 29, 2025
  If your Scag Power Equipment Lawn Mower is leaving strips of uncut grass between cutting paths, the issue is likely due to not enough overlapping between rows. Increase the overlap of each pass to resolve this.
J
jessica66Sep 4, 2025
What causes an uneven cut on uneven ground with a Scag Power Equipment Turf Tiger STT52V-26CH-EFI?
- J
  Jennifer BishopSep 4, 2025
  If your Scag Power Equipment Lawn Mower is producing an uneven cut on uneven ground, resulting in a wavy appearance, high-low scalloped cut, or rough contour, it is likely due to the uneven ground itself. You may need to reduce ground speed, raise the cutting height, and/or change the direction of the cut.

Scag Power Equipment Turf Tiger STT52V-26CH-EFI Specifications

General

Category	Lawn Mower
Manufacturer	Scag Power Equipment
Model	Turf Tiger STT52V-26CH-EFI
Engine Power	26 hp
Fuel Type	Gasoline
Cutting Width	52 inches
Cutting Height	1.5 - 5 inches
Weight	1, 250 lbs
Deck Construction	7-gauge steel
Transmission	Hydrostatic