Scag Power Equipment Turf Tiger STT61V-25KBD User Manual (English)

Questions and Answers:

M
Michael BlackJul 31, 2025
How to fix stringers (occasional blades of uncut grass) with my Scag Power Equipment Lawn Mower?
- D
  David FoxJul 31, 2025
  If your Scag Power Equipment Lawn Mower leaves occasional blades of uncut grass, it could be due to several reasons. First, ensure the engine is running at full RPM. If the ground speed is too fast, slow down to adjust for the conditions. Avoid cutting wet grass; wait until it has dried out. Check if the blades are dull or incorrectly sharpened, and sharpen them if needed. Also, inspect the deck for grass accumulation and clean the underside if it's plugged. Finally, check for slipping belts and adjust the belt tension if necessary.
B
Brianna ThomasAug 5, 2025
What to do if my Scag Power Equipment Turf Tiger STT61V-25KBD Lawn Mower has an uneven cut on flat ground?
- M
  Melissa ReedAug 5, 2025
  If your Scag Power Equipment Lawn Mower is producing an uneven cut on flat ground, resulting in a wavy, high-low appearance, scalloped cut, or rough contour, consider these potential causes: a worn lift from the blade (replace the blade), the blade being upside down (mount it correctly with the cutting edge toward the ground), grass accumulation under the deck (clean the underside of the deck), too much blade angle (adjust pitch and level), or a dull blade (sharpen the blade). For issues related to an improperly mounted deck or a bent spindle area, consult your authorized SCAG dealer.
S
Shannon MillsAug 10, 2025
Why is my Scag Power Equipment Turf Tiger STT61V-25KBD streaking?
- V
  Vincent SmithAug 10, 2025
  If your Scag Power Equipment Lawn Mower is leaving strips of uncut grass in the cutting path, several factors could be responsible. The blades might be dull or worn, or they may have been sharpened incorrectly; if so, sharpen the blades. The engine RPM might be too low, so ensure you run the engine at full RPM. Other potential causes include a slipping belt (adjust belt tension), a deck plugged with grass accumulation (clean the underside of the deck), ground speed being too fast (slow down), cutting wet grass (wait for it to dry), or bent blades (replace them).
L
lopezjaredAug 15, 2025
Why is my Scag Power Equipment Turf Tiger STT61V-25KBD Lawn Mower leaving a sloping ridge?
- R
  Ronald BradfordAug 15, 2025
  If your Scag Power Equipment Lawn Mower is leaving a sloping ridge across the width of the cutting path, it could be due to unequal tire pressures (check and adjust) or uneven wheels (check and adjust tire pressure). If the deck is mounted incorrectly or is not level side-to-side, consult your authorized SCAG dealer or check for level and correct it, respectively.
A
Amy PerkinsAug 19, 2025
How to prevent strips of uncut grass between cutting paths with my Scag Power Equipment Turf Tiger STT61V-25KBD Lawn Mower?

Scag Power Equipment Turf Tiger STT61V-25KBD Specifications

General

Category	Lawn Mower
Manufacturer	Scag Power Equipment
Model	Turf Tiger STT61V-25KBD
Engine	Kawasaki
Engine Power	25 HP
Cutting Width	61 inches
Transmission	Hydro-Gear ZT-3400
Speed Range	0 - 10 mph
Turning Radius	Zero-turn
Spindle Material	Aluminum
Blades	3
Fuel Capacity	12 US gallons
Tire Size Front	13 x 6.5 - 6
Tire Size Rear	24 x 12 - 12