3604/2018
8. Enter yes to complete the system initialization as seen in the example below.
9. It will take approximately 15-20 minutes for the node(s) to initialize. Once complete the HC3 web
interface will be accessible using the congured LAN IP of the node(s).
10. See the applicable User Guide for your software version for information on rst-time system
conguration if needed.
System Initialization
WARNING
If any nodes are missing from the list DO NOT proceed. Type ctrl+c and
enter no to the prompt. You will return to the commandline.
Run the node conguration command again on all nodes and ensure it
completes successfully before attempting initialization again.
To Next Page
Loading...
