Explanation of Symbols
Notified Body (TÜV Rheinland)
Consult the instruction for use
Disposal information: Should you wish to
dispose of the article, do so in accordance
with current regulations. Details are
available from your local authority
Type BF applied part
Basic safety and essential performance
requirement
Temperature limits
European Authorized Representative
Manufacturer
LOT
Manufacture batch code
23
FCC Statement
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation.
This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the
following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and
receiver.
3. Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
4. Consult the dealer or an experienced adio/TV technician for
help.
5. FCC Caution: To assure continued compliance, (example –
use only shielded interface cables when connecting to
computer or peripheral devices). Any changes or
modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate this equipment.
6. This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
7. This device complies with FCC radiation exposure limits set forth for
an uncontrolled environment. End users must follow the specific operating
instructions for satisfying RF exposure compliance. This transmitter must not
be colocated or operating in conjunction with any other antenna or
transmitter.
24
To Next Page
Loading...