ScanBas 365 Page 11
5 Tips and tricks
5.1 In Edit mode
• You can add all available measurement boxes at once to a measurement panel by right
clicking the panel and selecting "Add all measurement boxes"
• You can drag and drop a measurement box into a graph panel or spider panel to add that
measurement to the panel.
5.2 Calibrating sensors
• If you know a sensor has an offset on its value, or you want to change a depth reference to
be from the keel instead of the surface, you can calibrate an offset on the sensor value. This
can be done on any measurement. Right click the respective mesurement box and select
"Calibrate Sensor".
5.3 Change Units
• You can change the units of the measurements on Scanbas 365 by going to: Main menu →
Settings → Units
5.4 Display Brightness
You can reduce the display brightness by clicking the sun icon in the top right corner of the screen.
To Next Page
Loading...