ScanBas 365 Page 5
2.3.2 Graph panel
The graph panel will show a graph of a measurement value as it changes over time, as well as
echograms from TrawlEye sensors.
The software automatically groups similar measurements (eg. all temperatures) but splits different
types of measurements into different sub-panels (temperature, distance, depth etc.). However, all
measurements in a given graph panel shares a time axis (x-asis). This makes it easy to both read the
value of each graph, while still being able to correlate changes in different types of measurements.
Echograms from TrawlEye sensors are displayed in a graph panel as well.
2.3.3 Spider panel
The spider panel displays deviations from nominal value on any
measurements in a spider graph form. When the values are nominal, or
close to nominal, the points corresponding to a value is green and close
to center. If all the values are within specified limits the area of the graph
will be green.
With increasing deviation, the point moves farther away from the center,
and will change to red when exceeding the alarm limit. When any value
exceeds its limit, the area of the entire graph will be red.
This makes the spider panel an effective way of monitoring deviations of
several important measurements at the same time.
Note: Nominal values can be set at any time with a button press. See 3
Alarm settings and nominal values
2.3.4 Symmetry panel
The symmetry panel displays a graphical representation of the doors and trawl opening with
superimposed measurements of depths, temperatures, distances etc.
2.3.5 Codend panel
This panel displays a graphical view of the codend, with superimposed measurements of catch,
temperature, twists etc.
2.4 Placing and resizing panels
When dragging a panel to the screen view, a placement indicator
with several drop targets will indicate where the panel will be
placed. Additionally the area it will be placed will be highlighted
with a blue color.
This allows you to place a new panel above, below or to any side of
an existing panel.
To Next Page
Loading...