58
www.scanmaskin.com
6. Warranty
This product from Scanmaskin Sweden AB comes with a twelve month warranty. If the pro-
duct does not function satisfactorily during this period, Scanmaskin will return the product to
full working order for normal use which the product is intended for – with no charge for labor
or spare parts, according to the following conditions:
1. The warranty only applies to persons that have legal right to the equipment during the
warranty period.
2. The manufacturer’s undertaking is limited to the repair of defective parts or the replace-
ment of these according to the manufacturer’s assessment. Costs and risks for transport as
well as dismantling and reinstallation of the product / products and other direct or indirect
costs, associated with the repair in question, are not covered by this warranty.
3. Periodic inspections, adjustments, maintenance work and changes are not covered by the
warranty.
4. Scanmaskin is not liable for any damages to grinding discs or other similar equipment.
5. The warranty only applies to material and design deficiencies and does not apply in the
following cases:
a. Damage caused through accidents, carelessness, changes, use of spare parts or
grinding tools that are not original components, or incorrect use and installation.
b. Damage caused by lightning, water, fire, vandalism, incorrect mains voltage, incor
rect ventilation or other causes that lie outside of the manufacturer’s control.
6. Scanmaskin reserves the right to modify the design – or make improvements without obli-
gation to change previously manufactured products.
7. All warranty repairs must be carried out by Scanmaskin or by a Scanmaskin authorized
repair workshop. Costs for repairs, carried out by an unauthorized workshop, will not be
reimbursed by Scanmaskin. If such repairs damage this product these are not cover by the
warranty agreement.
To Next Page
Loading...
