What to do if my SCC MAM–200 Controller shows OVERLOAD?
If your SCC Controller displays 'OVERLOAD', it could be due to several reasons such as low voltage, blocked tubes, worn bearings, mechanical failure, or incorrect data settings. To resolve this, verify the set data, voltage, bearings, tubes, and other components.
How to fix a SHORT CIRCUIT error on my SCC Controller?
If the SCC Controller displays 'SHORT CIRCUIT', it's likely due to incorrect cable connections or incorrect data settings. You should check the wiring and ensure the data is set correctly.
What causes LACK PHASE error on SCC Controller?
If the SCC Controller shows 'LACK PHASE', this indicates a missing power phase or a damaged contactor. Inspect the power supply and contactors terminal to troubleshoot.
Why is my SCC MAM–200 showing a BLOCK error?
If the SCC Controller displays 'BLOCK', it might be due to low voltage, blocked tubes, worn bearings, mechanical failure, or incorrect set data. Check the set data, voltage, bearings and tubes.
How to troubleshoot an UNBALANCE error on SCC MAM–200?
If the SCC Controller displays 'UNBALANCE', the cause may be power unbalance or a damaged contactor. You should check the power supply, contactors, and the motor.
What does AIR P HIGH mean on my SCC MAM–200 Controller?
If your SCC Controller is showing 'AIR P HIGH', it means the pressure is too high or the pressure sensor has failed. Check the pressure and the pressure sensor to resolve this.
How do I correct a WRONG PHASE SEQUENCE on my SCC MAM–200 Controller?
If the SCC Controller displays 'WRONG PHASE SEQUENCE', it's likely due to a reversed phase sequence or a phase being off. You should check the wiring.
What does AIR T HIGH mean on my SCC Controller?
If the SCC Controller indicates 'AIR T HIGH', it could be due to poor ventilation or insufficient lubricant. Inspect the vent condition and the lubricant amount.
What should I do if my SCC Controller says LACK WATER?
If the SCC Controller reports 'LACK WATER', the water pressure switch might be damaged. You should check the water pressure switch.
How to resolve AIR P SENSOR FAULT on SCC MAM–200 Controller?
If your SCC Controller displays 'AIR P SENSOR FAULT', it could be due to a disconnected cable, a damaged sensor, or the cable being connected in reverse. Check the wiring and the sensor.
Key operational notices and safety precautions for the compressor controller.
Detailed explanation of the function of each button on the controller interface.
Process for viewing and modifying custom parameters, including password entry.
Detailed table of customer parameters, their preset values, and functions.
Details on short circuit, block, overload, and phase protection for the motor and fan.
Details on specific alarms like Air Filter, Oil Filter, O/A, Lubricating Oil, and Grease.
Details on short circuit, block, overload, lack phase, and unbalance protection for the motor.
Protection against high air temperature, triggering an alarm and machine stop.
Protection against incorrect phase sequence causing the motor to not start.
Protection against high air pressure, triggering an alarm and machine shutdown.
Protection against pressure or temperature sensor failures, causing alarm and stop.
Protection when fan does not run despite high exhaust temperature.
Steps to check faults and history faults via the 'RUN PARAMETER' and 'CURRENT FAULT' menus.
Details on how the MAM-860 controller operates with other MAM series compressors in a network.
Procedure for configuring the controller to operate as a master unit in sequence mode.
Procedure for configuring the controller to operate as a slave unit in sequence mode.
How master controls compressor activation and deactivation in sequence mode.
Methods to check received and sent messages in sequence or COM mode.
Details on MODBUS RTU support, baud rate, and communication parameters.
General| Brand | SCC |
|---|---|
| Model | MAM–200 |
| Category | Controller |
| Language | English |
To Next Page
