Instruction Manual for LT 52 Control Panel
9
Date: 01.03.2018
8310027 BA / EN
Alarm RemedyPossible cause
On display of the ”Water Tank”
fill level:
The water tank is empty
Fill tank.
On display of the ”Waste Water
Tank” fill level:
The waste water tank is full.
Empty tank.
4.2 Faults
A flat battery or defective fuse is the cause of most faults in the 12V system.
For targeted fault location and troubleshooting, the battery must be fully charged and the
system must be connected to the 230V mains supply.
If the leisure battery is discharged, the 12V supply can be re-established by starting the en-
gine.
If fuses are blown: Refer to the instruction manual for the relevant EBL... electroblock for
information on voltage distribution and fusing. .
When it is not possible to rectify a fault based on the following table, please contact Schaudt
customer service (for address, see Page 11).
Start the
engine
Flat vehicle
fuses
To Next Page
Loading...
