Scheppach AC10/8V - Page 35

www.scheppach.com · service@scheppach.com
14. Check the power tool for potential damage
- Protective devices or other parts with minor damage must be carefully inspected to ensure that they function correctly
and as intended prior to continued use of the power tool.
- Check whether the moving parts function faultlessly and do not jam or whether parts are damaged. All parts must be
correctly mounted and all conditions must be fullled to ensure fault-free operation of the power tool.
- Damaged protective devices and parts must be properly repaired or replaced by a recognised specialist workshop,
insofar as nothing di󰀨erent is specied in the operating manual.
- Damaged switches must be replaced at a customer service workshop.
- Do not use any faulty or damaged connection cables.
- Do not use any electric tool on which the switch cannot be switched on and o󰀨.
15. Have your electric tool repaired by a qualied electrician
- This electric tool conforms to the applicable safety regulations. Repairs may only be performed by an electrician
using original spare parts. Otherwise accidents can occur.
16. Attention!
- For your own safety, only use accessories and additional equipment that are indicated in the operating manual or
have been recommended or indicated by the manufacturer. Use of other tools or accessories that those recom-
mended in the operating manual or in the catalogue could represent a personal danger to you.
17. Noise
- Wear hearing protection when using the compressor.
18. Replacing the connection line
- If the connection line is damaged, it must be replaced by the manufacturer or an electrician to avoid danger. There
is a risk of electric shock.
19. Inating tyres
- Check the tyre pressure immediately after lling using a suitable pressure gauge, e.g. at a petrol station.
20. Street-legal compressors in construction site operation
- Ensure that all hoses and xtures are suitable for the maximum permissible working pressure of the compressor.
21. Set-up location
- Only set up the compressor on a at surface.
22. In case of pressures above 7 bar, it is recommended to equip supply hoses with a safety cable (e. g. a wire rope).
23. Avoid over-stressing the piping system by using exible hose connections to prevent kinking.
24. Use a residual current circuit breaker with a trigger current of 30 mA or less. Use of an RCD reduces the risk of
electric shock.