www.scheppach.com
GB
|
31
m Risk of device damage!
The device is supplied without motor or gearbox
oil.
ATTENTION! Before operating, you must ll it
with fuel.
•
• Pour in the fuel carefully. Avoid spilling!
•
Draining fuel. Fig. 40
• Hold a collection container beneath the fuel drain
bolt.
• Unscrew the tank cap and remove it.
• Allow the fuel to run out completely.
•
Start on the unit
Do not start the unit until it has been completely as-
sembled.
m Danger of injury!
Do not operate the device unless you did not
nd any faults. If a part has become defective,
make sure to replace it before you use the device
again.
Check before use!
• Check the safe condition of the device:
• Check the device for leaks.
• Check the device for visual defects.
• Check that all parts of the device have been se-
• Check that all safety devices are in proper condi-
tion.
• Check the battery tray on top of the engine for de-
the battery pack in the engine battery tray on top of
-
in some instances.
m Danger of injury!
Before starting work, always check the ground and
-
vice.
Start Fig. 21 - 27 + 41
Choke lever:
Warm engine / choke closed:
Cold engine / choke open:
Once the machine has been set up properly, start the
engine as follow:
1.
2.
3.
4.
5. Pull the recoil starter handle 3-5 times to start the
6.
7.
8. Wait a little while and then close the choke lever
9. When the engine is running and idling. The throt-
10.
To release more line, tap the cutting line head
against the round with engine at top speed: the
line will be released automatically and the knife
11. If meet any problems, press the engine switch to
stop cutting head working, release the throttle le-
12. If any problem occurs, pull the pin of safety belt,
13. If the machine is hot, the throttle level can be ad-
machine.
Note: If the engine does not start up even after sev-
eral attempts, read the section „Engine troubleshoot-
Note: Always pull the starter cord out in a straight
line. If it is pulled out at an angle, then friction will oc-
cur on the eyelet. As a result of this friction, the cable
will become frayed and will wear away faster. Always
hold the starter handle when the cable retracts.
Never allow the cable to snap back when it has been
pulled out.
Note: Do not start the motor in tall grass.
m Attention: When the engine has been switched
therefore do not close to cutting head of brush cutter
until the cutter has come to a standstill!
• Remove the battery pack. The battery pack may
To Next Page
Loading...
