www.scheppach.com
32
|
GB
9. Working instructions
Extending the cutting line
Caution! Do not use any kind of metal wire or metal
wire encased in plastic in the line spool. This may
-
ting line, run the engine at full speed and tap the line
spool on the ground. This will automatically extend
The blade on the safety shield will cut the line to the
m Important: Remove all grass and weed remnants
at regular intervals to prevent the shaft tube overheat-
ing. Lawn, grass and weed remnants become trapped
under the safety shield and prevent the shaft tube
-
Dierent cutting methods
-
cess, e.g. along fences, walls and foundations and also
vegetation so that a garden can be better prepared or a
m Attention: Even if it is used carefully, cutting
around foundations, stone or concrete walls, etc. will
Trimming/mowing
Swing the trimmer from side to side in a scything
motion. Always keep the line spool parallel to the
ground. Check the site and decide which cutting
Low trimming
Hold the trimmer right in front of you at a slight angle
so that the underside of the line spool is above the
ground and the line strikes the correct target. Always
cut away from yourself. Never draw the trimmer to-
wards yourself.
Cutting along fences/foundations
Approach wire mesh fences, lath fences, natural
stone walls and foundations slowly so that you can
cut close to them without striking the obstacle with
the line. If, for example, the line strikes stones, stone
walls or foundations, it will wear or fray. If the line
strikes wire fencing, it will break.
Trimming around trees
When trimming around tree trunks, approach slowly
so that the line does not strike the bark. Walk around
the tree, cutting from left to right. Approach grass or
weeds with the tip of the line and tilt the line spool
forwards slightly.
Warning! Take extreme care during mowing work.
When doing such work keep a distance of 30 meters
between yourself and other people or animals.
Mowing
When mowing, you want to cut all the vegetation
down to the ground. To do this, set the line spool at
an angle of 30° to the right. Place the handle in the
-
-
Warning! -
-
damage to cars, houses and windows.
Jamming
immediately. Remove the grass and scrub from the
Preventing recoil
When you work with the blade, there is a risk of recoil
-
es, tree stumps, stones or the like. This will throw the
the rotation of the tool. This can cause you to lose
fences, metal posts, boundary stones or foundations.
10. Maintenance
Before performing any maintenance or cleaning
spark boot plug.
1. Do not spray the unit with water. It damages the
engine.
2. Clean the unit with a cloth, hand brush, etc.
Maintenance schedule
12 hours of
use
24 hours of
use
36 hours of
use
clean clean replace
Spark plug check clean replace
Expert inspection is required:
•
• If the motor stops suddenly
•
• If the gears are damaged.
To Next Page
Loading...
