www.scheppach.com
30
|
GB
Important: Only use containers designed and ap-
proved for the purpose to transport and store fuel.
-
Never use oil for 4-cycle engine or use water cooled
2-cycle engine. It can cause spark plug fouling ex-
haust part blocking or piston ring sticking.
-
riod of one month or more, may clog the carburetor
or result in the engine foiling to operate property. Put
remained fuel into an airtight container and keep it in
the dark and cool room.
2. Fuel mixing table
Example:
1 l Petrol : 0,025 l 2-stroke oil
5 l Petrol : 0,125 l 2-stroke oil
Warning!
Take care of the emission of exhaust gases.
Always shut o engine before fuelling. Never add
fuel to a machine with a running or hot engine.
Take care of re!
8. Attachment and operation
ASSEMBLY
When assembling this machine, please follow the
instructions for assembly printed.
1. Assemble the handle on the machine. Fig. 4 -6
• Assemble the bike type handle on the machine:
right and left handle on the centre of handle holder.
• Last assemble the handle holder and tighten the
inner screws enough.
2. Mounting the shaft. Fig. 7
•
This is easier to do if you rotate the bottom of the
in place when it is completely lodged in the hole.
•
3. Assemble the safe guard. Fig. 11 13
• -
closed as standard accessories for tighting the
nuts enough. Please see the below pictures show-
ing.
m Warning! Use only original manufacturer‘s re-
-
ure to do so can cause poor performance, possible
machine without the guard assembled!
4. Assemble and disassemble the cutting head
grass trimmer / nylon cutting head. Fig. 14 - 15
• Release the nut.
turn the socket wrench clockwise, the nut will be
released.
•
Remove another shield after release the nut. Still
shaft and rotate counter-clockwise, the Nylon cut-
•
Nylon cutting head clockwise, it will be replaced.
Brush cutter / Cutter blade
•
nut according to priority as below picture. Note
the blade rotation direction needs be same as be-
tighten nut counter-clockwise, ensure the nut is
tightened enough.
•
m Warning!
Please make sure the cutting head has been assem-
bled correctly before use!
Note: The packaging material is made of recycle
materials. Dispose of packaging materials in accord-
ance with regulations.
5. Fit the belt. Fig. 17 - 21
•
OPERATION
plastic guard hood for cutting blade mode or cutting
The integrated blade in the cutting line guard hood
automatically cuts the line to the optimum length.
Filling with fuel
m Danger of injury! Fuel is explosive!
Turn o and cool the motor down before lling
the tank with fuel. You must observe all safety
instructions relating to handing fuel.
To Next Page
Loading...
