www.scheppach.com
GB
|
33
Clean the air lter Fig. 28 - 31
-
ing too little air to the carburetor. Regular checks are
therefore essential.
•
•
•
and allow drying naturally.
Important:
m Warning!
Never run the engine without the air lter ele-
ment installed.
Lubricate angle transmission
Lubricate with lithium-based grease. Remove the
screw and put in the grease, turning the shaft manu-
ally until grease emerges, then replace the screw.
Storing the unit
After cutting, clean the unit thoroughly. Store the unit
in a dry room allow the motor to cool down before-
hand.
Important hint in case of sending the equipment
to a service station:
Due to security reasons please see to it that the
Service information
Please note that the following parts of this product
-
consumables.
Line spool, cutting blade, spark plug, air
Spare parts and accessories can be obtained from
our service centre. To do this, scan the QR code on
the cover page.
11. Cleaning and storage
Cleaning
• -
cure hold.
•
• Remove the battery pack.
Replacing the line spool/cutting line Fig. 35 - 39
1. -
tion 8.4 Assembly. Press the spool together and
2. Take the spool plate out of the line spool housing.
3. Remove any remaining cutting line.
4. Place the new cutting line in the center and hang
the loop which has formed into the recess in the
5. Wind the line onto the spool counter-clockwise
and under tension. The spool splitter will sepa-
6. Hook the last 15 cm of the two ends of the line
onto the opposite lying line holders of the spool
7. Thread the two ends of the line through the metal
eyelets in the line spool housing.
8. Press the spool plate into the line spool housing.
9. Pull the two line ends sharply to release them
from the line holders.
10.
11. Cut the excess line to a length of around 13 cm.
This will reduce the load on the engine when
starting and warming up.
12.
are replacing the complete line spool, skip points
3-6.
Grinding the safety hood blade
The safety hood blade can become blunt over time.
• When you notice this, undo the screw holding the
safety hood blade on the safety hood.
• Clamp the blade in a vise.
•
that the angle of the cutting edge is not altered in
Replacing and resharpening the cutting blade at the
end of the mowing season always resharpen the cut-
with a new one.
Unbalanced blades will cause the brush cutter to vi-
brate violently-risk of accident!
Change and clean the spark plug Fig. 32 - 33
1. Once the engine has cooled, remove the spark
plug using the socket spanner supplied.
2. Clean the plug with a wire brush.
3. Using a feeler gauge; set the gap to 0.5-0.7 mm.
4. Install the spark plug carefully by hand, to avoid
cross-threading.
5. After the spark plug is seated, tighten with span-
ner to compress the washer.
To Next Page
Loading...
