www.scheppach.com
36
|
GB
13. Troubleshooting
-
ment fails to work properly. If the problem still persists after working through the list, please contact your nearest ser-
vice workshop.
Important hint in case of sending the equipment to a service station:
Fault Possible cause Remedy
not start
• Correct starting procedure not followed
• Sooted or damp spark plug
• Incorrect carburetor setting
• Blade or nylon cutter mounted incorrectly
• No fuel in the tank
•
• Clean the spark plug or replace it with a new
one
• Contact an authorized customer service outlet
• Reassemble the blade or nylon cutter
• Check the fuel level
but does not develop
its full power
• Incorrect choke lever setting
•
• Incorrect carburetor setting
• Cutting blade blunt
•
•
• Contact an authorized customer service outlet
• Have cutting blade resharpened /replaced
The engine does not
run smoothly
• Incorrect electrode gap on the spark plug
• Incorrect carburetor setting
•
• Contact an authorized customer service outlet
Engine smokes exces-
sively
• Incorrect fuel mix
• Incorrect carburetor setting
•
• Contact an authorized customer service outlet
If the temperature of
machines is too high
• Engine is overloaded • Insure the machines have rest at regular time
To Next Page
