www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
32
|
GB
The running direction is marked with an arrow on the
upwards and put on the saw chain (4, beginning at the
tip of the bar.
Then assemble the guide bar with the saw chain as
follows:
• Place the guide bar with the saw chain on the chain
wheel (16) and guide bolt (17).
• Place the saw chain round the chain wheel (16).
Cause the chainsaw to the sprocket and check
•
the lock nut (5).
Tensioning the saw chain
Warning!
• Make sure the saw chain (4) is inside the guide
groove of the guide bar (7).
• Turn the knob (Fig. 3/5a) clockwise until the saw
• When cold, it should be possible to lift the chain in
the middle of the guide bar approx. 5 mm.
• When warm, the saw chain will expand and slacken
• If the saw chain is re-tensioned when hot, it must
be loosened again when the sawing work has been
completed.
• Otherwise, the contraction which takes place as
tension.
• A new saw chain requires a running-in period of
important at this stage. After running in, check
8. Initial operation
Check also that the chain lubrication and the oil
gauge are in good working order (see Fig. 4). When
the oil lever is approx. 5 mm from the bottom mark,
• Switch on the chain saw and hold it above the ground.
Be careful not allow the chainsaw to touch the ground.
Customer Service. (Be sure to read the section
“Filling in chain oil and chain lubrication” on this
point).
•
(see the section “Tensioning the saw chain” on this
point).
•
also the section “Releasing the chain brake”).
To switch on:
• Release the chain brake (3), push in the lock (11)
and press the power switch (13).
• Place the lowest claw (Fig 2, J) on the wood . Raise
wood. Move the chain saw back a little and place
the claw further down.
• Be careful when sawing splintered wood as pieces
at high speed .
To switch o
• Release either the ON/OFF switch (13) on the rear
grip.
• The release of ON/OFF switch results the stop of
This is normal and safe for the proper operation of
the chainsaw.
•
Clean the saw chain and guide bar and replace the
chain guard.
• If the chain brake is activated the chainsam will be
Explanation of the operation indicator (Fig. 2, 18):
Green LED:
The green LED comes on when the device is in use.
9. Working instructions
Transporting the chainsaw
the plug from the power socket and slide the chain
guard over the rail and chain. If several cuts are to
be performed with the chain saw, the saw must be
To Next Page
Loading...
Need help?
General
