www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
13. Troubleshooting
Warning: In the interests of operational safety, always switch off the saw and remove the mains plug before carrying out
maintenance work.
Fault Possible causes Action
Saw blades break Tension incorrectly set Set the correct tension
Load to great Feed the workpiece more slowly
Incorrect saw blade variety Use the correct saw blades
Workpiece not fed straight Avoid exerting pressure from the side
Motor does not function Mains Gable faulty Change faulty parts
Motor faulty Call customer service. Do not at-
tempt to repair the motor yourself as
this should be carried out by trained
personnel.
Vibration
NOTE: The saw vibrates slightly when
the motor is running in normal opera-
tion.
Saw incorrectely installed Refer to the instructions given earlier in
this manual for information on installing
the saw
Unsuitable underlay The heavier the work bench is,the
less the vibration. A bench made from
ply wood always vibrates more than
one made from solid wood. Select the
work bench best suited to your working
conditions
The work bench is not screwed down
or is on the motor
Tighten the locking lever
The motor is not secured Securely screw the motor in place
Saw blade swings out
Holders not aligned straight
Holders not aligned Losen the screws with which the hold-
ers are fastenedto the arm. Align the
holders so that they are perpendicular
to each other and retighten the screws.
23 / 136
EN
To Next Page
Loading...
Need help?
General
