To Next PageTo Next Page
What to do if chuck won't stay attached to spindle of Scheppach Power Tool?
If the chuck will not stay attached to the spindle and falls off when trying to install it on your Scheppach Power Tool, it is likely due to dirt, grease, or oil on the face of the spindle or the tapered surface of the chuck. Use household detergent to clean the surfaces of the spindle and chuck.
Why is workpiece torn loose from hand using Scheppach Power Tool?
If the workpiece is torn loose from your hand while using the Scheppach Power Tool, it is likely because the workpiece is not supported or clamped. Make sure to support or clamp your workpiece securely.
What to do if drill bit binds in workpiece of Scheppach Power Tool?
If the drill bit binds in the workpiece when using your Scheppach Power Tool, it could be due to: * The workpiece pinching the drill bit or excessive feed pressure. Support or clamp the workpiece. * Improper belt tension. Adjust the belt tension.
How to fix excessive drill bit run-out on Scheppach Power Tool?
Excessive drill bit run-out or wobble in your Scheppach Power Tool can be caused by: * A bent drill bit. Use a straight drill bit. * Worn spindle bearings. Replace the bearings. * The drill bit not being clamped centrally in the chuck. Check the centering of the drill. * The chuck not being properly installed. Properly install the chuck.
Why is the hole not round when using my Scheppach Power Tool?
If the drill leads off or the hole is not round when using your Scheppach Power Tool, it could be due to: * Hard grain in the wood or unequal lips and/or angle. Resharpen the drill bit. * A bent drill bit. Replace the drill bit.
How to fix a noisy Scheppach Power Tool?
Noisy operation of your Scheppach Power Tool can be caused by: * Incorrect belt tension. Adjust the belt tension. * Dry spindle. Test the spindle. * Loose spindle pulley. Check the retaining nut on the pulley and tighten if necessary. * Loose motor pulley. Tighten the set screw in the motor pulley.
General| Drilling | Yes |
|---|---|
| Screwdriving | - |
| Product color | Blue, Grey |
| Input power | 500 W |
| Power source | AC |
| AC input voltage | 230 - 240 V |
| AC input frequency | 50 Hz |
| Idle speed (max) | - RPM |
| Chuck capacity (max) | 16 mm |
| Drilling diameter in steel (max) | - mm |
| Product type | Bench drill press |
| Housing material | Steel |
| Drill table size (WxD) | 160 x 160 mm |
Weight and Dimensions| Depth | 460 mm |
|---|---|
| Width | 380 mm |
| Height | 250 mm |
| Weight | 15420 g |
