www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
20
|
GB
2. Device description (g. A)
1. Speed control
2. Locking mechanism for on switch
3. Handle
4. Additional handle
5. Suction adjustment
6. Main switch
7. Dust extraction connector
8. Grinding plate
9. Sanding paper 6 pcs
(grain size: 80, 100, 120, 150, 180, 240)
10. Flexible suction hose
11. Dust bag
12.
13. Replacement carbon brushes 2 pcs
14. Screwdriver
15.
16. Connection adapter
3. Scope of delivery
•
• Hose 1500 m
• Sanding paper 225 mm
• Adapter
• Screwdriver
• Carbon brush
•
• Additional handle
• Dust bag
• Shoulder strap
• Operating manual
4. Proper use
The intended use of this power tool is the sanding of
as a preparation before painting or wallpapering.
This power tool is neither suited for the preparation
of small areas, corners and edges, nor for the re-
moval of wallpaper and the grinding of ceilings and
wet grinding.
Do not use the power tool for cutting or roughing or
polishing. Do not use it together with wire brushes.
Do not treat asbestos containing materials with this
power tool.
-
ner. The user/opera-
tor, not the manufacturer, is responsible for damages
An element of the intended use is also the obser-
-
operating manual.
1. Introduction
Manufacturer:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer
and success.
Note:
laws, the manufacturer of this device assumes no
device arising from:
• Improper handling
•
•
specialists
• Installing and replacing non-original spare parts,
• Improper use
•
electrical regulations and VDE provisions 0100,
DIN 57113 / VDE 0113 not being observed
Note:
Read the whole text of the operating manual before
purpose.
The operating manual includes important instructions
for safe, proper and economic operation of the de-
vice, for avoiding danger, for minimising repair costs
extending the service life of the device.
-
Keep the operating manual at the device, in a plastic
sleeve, protected from dirt and moisture.
-
sonnel before starting the work.
been trained to use it and who have been instructed
with respect to the associated hazards. The required
minimum age must be observed.
-
to the operation of such machines must also be ob-
served.
occur due to a failure to observe this manual and the
To Next Page
Loading...
Need help?
General
