www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB
|
27
12. Troubleshooting
Fault Possible cause Remedy
Power tool does not start
power tool
Power cord or plug defective Have an electrician check the tool
Other electric malfunction of the power tool Have an electrician check the tool
Power tool does not operate
with full power
Extension cord too long and/or cross-
section too small
Use extension cord with permissible length
and/or adequate cross-section
low
Connect power tool to an appropriate
Poor operation results
Sanding plate worn out Have sanding plate replaced
Considerable dust formation Brush edge worn out Have brush edge replaced
Dust extraction not connected/switched on Connect/switch on dust extraction
To Next Page
Loading...
