www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB
|
21
Idle setting screw (g. 3)
-
-
ti-clockwise.
Warning! Other work on the carburettor must be car-
8. Operation
know
and follow the safety notices.
motor, disconnect the spark plug connector and wear
-
-
ered machines).
• Observe national stipulations during work when us-
•
hazardous area.
• Check the working environment for foreign bodies
and remove them.
•
• Check the earth auger for correct functioning and
its safe operating condition.
•
in case of emergencies.
• Hold on to the earth auger with both hands when
working.
•
process as well.
• Do not lean too far forwards when working.
•
not rotate in idling mode when the motor is warm.
•
changes to the machine‘s behaviour.
• -
• Drill the hole in the ground in several sections so
• Keep the auger vertical, do not twist it!
•
•
• Other applications are not permitted.
7. Before operation
Assembly
• Place the motor casing on a work bench. Place the
both holes are aligned.
•
•
Fuelling g. 1
•
• Pour in the fuel mixture using a funnel.
•
•
Fuel mixture
The auger‘s motor is a two-stroke motor. It is driven
a research octane count of at least 91. Lubrication of
oil.
Do not mix the fuel mixture in the fuel tank. Use the
mixing container supplied or another appropriate
• Use fresh, clean fuel. Water and contaminants in
• Refuel in a well-ventilated area with the motor not
-
machine in a building where the petrol fumes can
•
•
•
•
Starter cord (g. 1)
Choke lever (g. 3)
the carburettor. In the position, the air-petrol-mix-
ture is enriched for the motor‘s cold start. The po-
sition is used for the operation of the motor and for a
warm start.
To Next Page
Loading...
Need help?
General
