www.scheppach.com
GB
|
27
The machine can only be operated by persons who
were instructed concerning the operation of the ma-
chine and who are informed about the associated dan-
gers. The minimum age requirement must be complied
with.
In addition to the safety requirements in these oper-
ating instructions and your country’s applicable regu-
lations, you should observe the generally recognized
technical rules concerning the operation of woodwork-
ing machines.
We cannot accept any liability for damage or accidents
which arise due to a failure to follow these instructions
and the safety instructions.
2. Device description (Fig. 1-18)
1 Case door
2 Door lock
3 Saw blade safety device
4 Saw blade guidance
5 Longitudinal limit stop
6 Table width enlargement
7 Tabletop
8 Clamping lever
9 Frame
10 On/O switch
11 Handle for saw blade tensioning
12 Handle for belt tensioning
13 Adjustment handle for sawblade guard
14 Mitre gauge (not shown / optional accessory)
3. Scope of delivery
• Bandsaw
• Saw table
• Saw blade
• Retainer plate
• Rail with scale
• Push stick
• Guide rail for lengthwise aligning stop
• Longitudinal limit stop
• Allen key (3x)
• Screwdriver
• Open-ended spanner (2x)
• Table width enlargement with guide rail for length-
wise aligning stop
• Fastening materials
• Original operating instructions
• Saw blade
1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear customer,
We hope your new tool brings you much enjoyment
and success.
Note:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by the
product that occurs due to:
• Improper handling,
• Non-compliance of the operating instructions,
• Repairs by third parties, not by authorized service
technicians,
• Installation and replacement of non-original spare
parts,
• Application other than specied,
• A breakdown of the electrical system that occurs
due to the non-compliance of the electric regu-
lations and VDE regulations 0100, DIN 57113 /
VDE0113.
We recommend:
Read through the complete text in the operating in-
structions before installing and commissioning the
device.
The operating instructions are intended to help the us-
er to become familiar with the machine and take ad-
vantage of its application possibilities in accordance
with the recommendations.
The operating instructions contain important infor-
mation on how to operate the machine safely, profes-
sionally and economically, how to avoid danger, costly
repairs, reduce downtimes and how to increase relia-
bility and service life of the machine.
In addition to the safety regulations in the operating
instructions, you have to meet the applicable regula-
tions that apply for the operation of the machine in your
country.
Keep the operating instructions package with the ma-
chine at all times and store it in a plastic cover to pro-
tect it from dirt and moisture.
Read the instruction manual each time before operat-
ing the machine and carefully follow its information.
To Next Page
Loading...
Need help?
General
