www.scheppach.com
GB
|
37
15. Troubleshooting
Problem Possible cause Help
Motor does not work Motor, cable or plug defective,
fuses burnt
Housing cover open (limit switch)
Arrange for inspection of the machine by
a specialist. Never repair the motor your-
self. Danger! Check fuses and replace as
necessary
Close housing cover exactly
The motor starts up slowly and
does not reach operating speed.
Voltage too low, coils damaged,
capacitor burnt
Contact the utility provider to check the
voltage. Arrange for inspection of the mo-
tor by a specialist. Arrange for replace-
ment of the capacitor by a specialist
Motor makes excessive noise Coils damaged, motor defective Arrange for inspection of the motor by a
specialist
The motor does not reach its
full power.
Circuits in the network are over-
loaded (lamps, other motors, etc.)
Do not use any other equipment or mo-
tors on the same circuit
Motor overheats easily. Overloading of the motor, insu-
cient cooling of the motor
Avoid overloading the motor while cutting,
remove dust from the motor in order to
ensure optimal cooling of the motor
Saw cut is rough or wavy Saw blade dull, tooth shape
not appropriate for the material
thickness
Resharpen saw blade and/or use suitable
saw blade
Workpiece pulls away and/or
splinters
Excessive cutting pressure and/or
saw blade not suitable for use
Insert suitable saw blade
Saw blade is not running
straight
Guide has been wrongly set
Wrong saw blade
Set the saw blade guide according to the
operating instructions
Select a saw blade according to the
operating instructions
Burn marks appear on the wood
during the cutting work
Blunt saw blade
Wrong saw blade
Change the saw blade
Select a saw blade according to the
operating instructions
Saw blade jams during cutting
work
Blunt saw blade
Deposits on the saw blade
Guide has been set poorly
Change the saw blade
Clean the saw blade
Set the saw blade guide according to the
operating instructions
• These statements only apply to devices installed
and sold in the countries of the European Union
and which are subject to the European Directive
2012/19/EU. In countries outside the European Un-
ion, dierent regulations may apply to the disposal of
waste electrical and electronic equipment.
To Next Page
Loading...
Need help?
General
