international 23
Assembly
Handle
The compressor handle is to be assembled as follows:
Wheels, Fig. 3
1 When mounting the wheels (12), begin by placing a
wheel bolt with a washer through the wheel. Then insert
a washer and a hex head nut.
2 Slide the wheel through the clip under the tank.
3 Then fasten it with a disc, a safety glass, and a nut and
tighten them together.
4 Repeat this process for the second wheel.
Rubber Bumpers, Figure 4
Secure the rubber bumpers on the bracket on the front
side of the tank. Use the enclosed screws, washers, and
nuts.
Oil, Figure 5, 5.1
Warning: It is imperative that you check the oil level
before using the machine for the rst time!
Operation of the machine without oil will cause irrepara-
ble damage and invalidate the guarantee.
1 Remove the plastic oil ller plug located in the crank
box of the compressor housing.
2 Fill the crankcase with oil, until the oil level in the oil-
level indicator (16) reaches the centre of the circular
marking.
3 Close the opening using the sealing plug (14) included
in the delivery.
To Next Page
Loading...
Need help?
General
