international 29
Should the safety valve not work properly as described
above, immediately switch off the compressor and have
the safety valve examined by your dealer.
Do not work with the compressor when the safety valve
does not work properly, as described above.
GENERAL INSPECTION
1 Regularly check all the xing bolts for their tight seat.
2 Regularly check, at short intervals, the electric cable
for damages. A damaged cable must be replaced by
an electrician in order to avoid any danger.
CLEANING
1 Always keep the air inputs and outputs free and clean.
2 Regularly remove dust and dirt with a soft brush or a
soft cloth.
3 Regularly grease all moving parts.
4 When the compressor must be cleaned, wipe it with a
soft, moist cloth. A mild rinsing agent may be used, but
no alcohol, gasoline, or another cleaning agent.
5 Never use any caustic agents for cleaning plastic parts.
Attention: Water may never come into contact with
the compressor.
m Electric connection
Maintenance of the electric cable
The cable set may only be repaired or replaced by a
specialized workshop. In case of damage, contact your
dealer.
• The product meets the requirements of
EN 61000-3-11 and is subject to special connection
conditions. This means that use of the product at any
freely selectable connection point is not allowed.
• Given unfavorable conditions in the power supply the
product can cause the voltage to uctuate temporarily.
• The product is intended solely for use at connection
points that
a) do not exceed a maximum permitted supply imped-
ance “Z”, or
b) have a continuous current-carrying capacity of the
mains of at least 100 A per phase.
• As the user, you are required to ensure, in consulta-
tion
with your electric power company if necessary, that
the
connection point at which you wish to operate the
product meets one of the two requirements, a) or b),
named above.
To Next Page
Loading...
Need help?
General
