international 69
• Before working with the compressor, check the oil level.
It must be near the red circle as shown on the display.
• Attention: Oil must be filled in before the initial putting
into operation.
• After using the compressor, press the ON/OFF switch,
cut off the mains supply, and open the drain valve in
order to reduce the pressure.
• Do not try to remove a part from the machine while it
is pressurized.
• Make sure the lubrication oil is clean and always availa-
ble in sufficient quantity. Change the oil according to
the instructions given in the chapter „Maintenance „of
this manual.
• Wear safety gears including goggles or a screen, ear pro-
tection, breathing mask and protective clothing.
• After connection to the mains and switching on, the
machine starts automatically.
• Air escaping from the compressor may not be inhaled.
• Check the pressure control valve daily before starting work.
• Drain humidity from the tank. Avoid tank corrosion.
• Cut off the mains supply, remove the power supply
plug, and relieve the pressure before starting mainte-
nance work.
Wear goggles.
Wear ear protection.
Wear a breathing mask.
Never direct the output air from the compressor towards
a part of the body or a person. Never try to block the air
escape with your finger or a part of your body.
m Use as authorized
The machine meets all valid EC machine guidelines.
• The machine must only be used in technically perfect
condition and conscious of the risks, in accordance
with its designated use and the instructions set out in
the operating manual.
• Any functional disorders, especially those affecting the
safety of the machine, must be rectified immediately.
• The safety, working and maintenance instructions of
the manufacturer as well as the dimensions given in the
chapter „Technical data“ must be adhered to.
• The relevant accident prevention regulations and other,
generally recognized safety-technical rules must also
be adhered to.
• The machine may only be used, maintained, and ope-
rated by persons familiar with it and instructed in its
operation and procedures.
• Arbitrary alterations to the machine release the ma-
nufacturer from all responsibility for any resulting da-
mages.
• The machine may only be used with original accesso-
ries and original tools supplied by the manufacturer.
Any other use exceeds authorization. The manufactu-
rer is not responsible for any damages resulting from
unauthorized use; risk is the sole responsibility of the
operator.
m Remaining hazards
The machine has been built using modern technology in ac-
cordance with recognized safety rules. Some remaining ha-
zards, however, may still exist.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
