www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
20
|
GB
The specied vibration value was established in ac-
cordance with a standardized testing method. It may
change according to how the electric equipment is
used and may exceed the specied value in excep-
tional circumstances.
The specied vibration value can be used to compare
the equipment with other electric power tools.
The specied vibration value can be used for initial
assessment of a harmful eect.
Keep the noise emissions and vibrations to a
minimum.
• Only use appliances which are in perfect working
order.
• Service and clean the appliance regularly.
• Adapt your working style to suit the appliance.
• Do not overload the appliance.
• Have the appliance serviced whenever necessary.
• Switch the appliance o when it is not in use.
• Wear protective gloves.
7. Before putting the machine into
operation
Unpacking
• Open the packaging and remove the device care-
fully.
• Remove the packaging material as well as the
packaging and transport bracing (if available).
• Check that the delivery is complete.
• Check the device and accessory parts for trans-
port damage.
• If possible, store the packaging until the warranty
period has expired.
ATTENTION
The device and packaging materials are not toys!
Children must not be allowed to play with plas-
tic bags, lm and small parts! There is a risk of
swallowing and suocation!
Correctly using the device
• The high-pressure cleaner must be set on a level,
stable surface..
• It is recommended that you maintain the correct
operating position every time you use the machine
by placing one hand on the pistol and the other on
the lance.
• Never direct the water jet toward electrical lines or
the machine itself.
• It is normal for the pump to leak a little; this is nec-
essary to avoid damage to the pump when it is at
a standstill.
• Never use the equipment in potentially explosive
areas under any circumstances!
• The operating temperature must be between +5
Personal protective equipment
m CAUTION
• Wear protective clothing and safety goggles to pro-
tect against splash back containing water or dirt.
• During the use of high-pressure cleaners aerosols
can develop. Inhaling aerosols can cause health
damage. Depending on the application, completely
shielded nozzles (e.g. surface cleaner) that signi-
cantly reduce the emission of aqueous aerosols
can be used for high-pressure cleaning. The use
of such shielding is not possible with all applica-
tions. If the use of a completely shielded nozzle is
not possible, a respirator of the category FFP 2 or
the like should be used, depending on the environ-
ment to be cleaned.
Residual risks
Even if you use this electric power tool in ac-
cordance with instructions, certain residual
risks cannot be rules out. The following hazards
may arise in connection with the equipment’s
construction and layout:
• Lung damage if no suitable protective dust mask
is used.
• Damage to hearing if no suitable ear protection is
used.
• Health damage caused by hand-arm vibrations if
the equipment is used over a prolonged period or is
not properly guided and maintained.
6. Technical data
Mains voltage 220-230 V~ / 50 Hz
Power input 3200 W
Working pressure 15 MPa
Nominal pressure 22,5 MPa
Delivery rate 7,5 l/min
Max. water inlet pressure 0,4 MPa
Danger!
Sound and vibration
Sound and vibration values were measured in ac-
cordance with EN 60335.
L
pA
sound pressure level 83 dB(A)
K
pA
uncertainty 3 dB(A)
L
WA
sound power level 100 db(A)
K
WA
uncertainty 3 dB(A)
Wear ear-mus.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60335.
Vibration emission value a
h
≤ 2,5 m/s
2
To Next Page
Loading...
Need help?
General
