31
Odprava napak
V primeru napačnega delovanja, ki ni omenjen tukaj, se obrnite na prodajalca ali uvoznika.
Napaka Možen razlog Pomoč Nevarnost
Hidravlična oljna črpalka se ne
zažene
Ni električne napetosti Preverite vod za električno
napeljavo
Možnost električnega udara. To delo
naj opravi električar.
Izklopljeno toplotno stikalo
motorja
Ponovno priključite stikalo
znotraj stroja
Steber se ne premakne navzdol Nizek nivo olja Preverite nivo olja in da
napolnite
Možnost umazanja.To delo lahko
opravi upravljalec stroja.
Ena od ročic ni priključena Preverite priključke ročic Možnost ureznin.To delo lahko opravi
delavec na stroju.
Umazanija na tirih Očistite steber
Motor se zažene steber pa se
ne spusti navzdol
Napačna smer delovanja
3-faznega motorja
Preverite smer delovanja
motorja
Vzdrževanje in popravila
Vsa dela morajo biti opravljena s strani specializiranega osebja ob strogem upoštevanju navodil napisanih v tem priročniku.
Pred vsakim delom mora biti upoštevana vsa opisana preventiva: izklopite stroj, izključite vtič iz električne napeljave (izvle-
cite vtič). Na stroj denite oznako, ki opisuje razlog, da ne deluje: »Stroj ne dela zaradi servisnih del: Neavtorizirano osebje
se ne sme približati stroju ali ga izklopiti«.
Trouble shooting
In case of any malfunctions not mentioned here, contact your dealer‘s after-sales service.
Malfunction Possible cause Remedy Danger class
The hydraulic pump does
not start
No electric power Check cable for electric
power
Risk of electric shock.
This job must be done by a
service electrician.
Thermal switch of motor
cut off
Engage thermal switch
inside the motor casing
again
The column does not move
down
Low oil level Check oil level and refill Risk of getting dirty.
This job can be done by the
machine operator.
One of the levers not
connected
Check fixing of lever Risk of getting cut.
This job can be done by the
machine operator.
Dirt in the rails Clean the column
Motor starts but column
does not move down
Wrong turning direction of
3-phase motor
Check turning direction of
motor and change
Maintenance and repairs
All servicing jobs must be executed by specialized personnel under strict observation of the present operating instructions.
Before every work, every possible caution must be taken: Switch off the motor, disconnect the power supply (pull the plug, if nec-
essary). Attach a board to the machine explaining the reason for being out of order: “Machine out of order due to servicing
work: Unauthorized people must not come close to the machine or switch it on.”
To Next Page
Loading...
Need help?
General
