ww w.scheppach.com
30
|
GB
You can obtain information on collection points for
waste equipment from your municipal administration,
public waste disposal authority, an authorised body for
the disposal of waste electrical and electronic equip-
ment or your waste disposal company.
17. Troubleshooting
The table below contains a list of error symptoms and explains what you can do to solve the problem if your tool
fails to work properly. If the problem persists after working through the list, please contact your nearest service
workshop.
Problem Possible Cause Remedy
Motor stops starting
Overload protection device disengaged to
protect the log splitter from being damaged
Contact a qualied
Electrician.
Fails to split logs
Log is improperly positioned
Refer to ”operation”
section to perfect log
loading
Size of log exceeds the capacity of the
machine
Reduce log size
before operating
Wedge cutting edge is blunt Sharpen cutting edge
Oil leaks
Locate leak(s) and
contact your dealer
Log pusher moves jerkily, taking
unfamiliar noise or vibrating a lot
Lack of hydraulic oil and excessive air in the
hydraulic system
Check oil level for
possible relling.
Contact your dealer
Oil leaks around the cylinder ram or
from other points
Air sealed in hydraulic system while operating
Loosen bleed screw
by some rotations
before operating the
log splitter
Bleed screw is not tightened before moving
the log splitter
Tighten bleed screw
up before moving the
log splitter
Oil drain screw loose
Tighten the oil drain
screw rmly
Hydraulic control valve assembly and/or seal
(s) worn
Contact your dealer
To Next Page
Loading...
Need help?
General
