www.scheppach.com
40
|
GB
15. Troubleshooting
Fault Possible cause Remedy
Motor does not work Motor, cable or plug defective, fuses
burnt
Arrange for inspection of the machine by a
specialist.
Never repair the motor yourself. Danger!
Check fuses and replace as necessary
The motor starts up
slowly and does not
reach operating speed.
Voltage too low, coils damaged,
capacitor burnt
Have an electrician check the voltage.
Arrange for inspection of the motor by a specialist.
Arrange for replacement of the capacitor by a
specialist
Motor makes exces-
sive noise
Coils damaged, motor defective Arrange for inspection of the motor by a specialist
The engine does not
reach full power.
Circuits in the network are overload-
ed (lamps, other motors, etc.)
Do not use any other equipment or motors on the
same circuit
Motor overheats easily.
cooling of the motor
Avoid overloading the motor while cutting, remove
dust from the motor in order to ensure optimal
cooling of the motor
Saw cut is rough or
wavy
Saw blade dull, tooth shape not ap-
propriate for the material thickness
Re-sharpen saw blade and/or use suitable saw
blade
Workpiece pulls away
and/or splinters
Excessive cutting pressure and/or
saw blade not suitable for use
Insert suitable saw blade
To Next Page
Loading...
Need help?
General
