Scheppach HMS850 Original Instruction Manual

www.scheppach.com
30
|
GB
Explanation of the symbols on the device
Symbols are used in this manual to draw your attention to potential hazards. The safety symbols and the accompa-
nying explanations must be fully understood. The warnings themselves will not rectify a hazard and cannot replace
proper accident prevention measures.
Read and observe the instructions manual and safety regulations before
starting the machine!
Wear ear-mu󰀨s!
Wear a breathing mask. Dust which is injurious to health can be generated
when working on wood and other materials. Never use the tool to work on
any materials containing asbestos!
Wear safety goggles. Sparks generated during working or splinters, chips
and dust emitted by the device can cause loss of sight.
WARNING! Risk of injury! Never reach into the planing knife during oper-
ation.
Overload switch
The product complies with the applicable European directives.
m Attention!
We have marked points in this operating manual that impact your safety
with this symbol.

Scheppach HMS850 Specifications

General

Motor Power	1250 W
Planing Width	204 mm
Max Planing Depth	2 mm
Max Thicknessing Height	120 mm
Feed Rate	8 m/min
Table Size	737 x 210 mm
Cutter Block Speed	8000 rpm
Thicknessing Width	204 mm
Motor	230 V, 50 Hz