www.scheppach.com
30
|
GB
Fast =
langsam schnell
vitesse lente vitesse rapide
slow fast
Pomalu rychle
Pomalý rýchly
Počasnega
hitrega
lassú gyors
бавно бързо
Nopea hidas
Slow =
langsam schnell
vitesse lente vitesse rapide
slow fast
Pomalu rychle
Pomalý rýchly
Počasnega
hitrega
lassú gyors
бавно бързо
Nopea hidas
Handlebar (g. A)
in the downward position. When the compactor is to be
Handlebar Latch Pin (g. G)
position for transporting and stowing.
adjustment bolt.
Lift Point (4) (g. A)
Used to lift the machine with crane or other lifting de-
vice.
Belt Guard (g. H)
Remove this guard to gain access to the V-belt. Nev-
er run the compactor without the V-belt guard. If the
V-belt guard is not installed, the possibility exists that
your hand may get caught between the V-belt and
clutch, thus causing serious injury and bodily harm.
Exciter
An eccentric weight mounted on the exciter shaft con-
tained within exciter housing is driven at high speed by
a clutch and belt drive system. This high speed shaft
revolution causes the rapid lifting and downward ram-
ming motion of the machine as well as imparting a for-
ward motion.
Engine switch (g. A)
-
position for the engine to run.
stops the engine.
Running the engine with dirty oil can cause premature
engine wear and failure.
Changing oil regularly is extremely important.
Oil Drain Hoe (g. L)
Running the engine with dirty oil can cause prema-
ture engine wear and failure. Changing oil regularly
equipped to drain oil into appropriate receptacle.
wheel kit. The machine engine must not be operated as
long as the machine is on the wheel kit. Before starting
the machine, remove the wheel kit!
•
• Carefully press the machine forward using the steer-
• The wheel kit must be locked into the place with the
• The machine can now be moved using the steering
The wheel kit is disassembly in reverse order.
m Attention: Only use the wheel kit on a level and sol-
id surface and for short distances.
Paving Pad Kit (g. D)
The transparent rubber paving pad allows to compact
concrete slabs, stones, bricks and blocks silently and
gently.
Align the holes in the base plate, paving pad and clamp
Engine oil (g. E)
m Check engine oil before commissioning!
9. Commissioning
m ATTENTION!
Always make sure the device is fully assembled
before start-up!
Hand Grip (g. A)
to maneuver the compactor.
Shift Stick (g. A + F)
compactor will move in reverse direction.
Throttle Control (g. A)
-
gine run faster or slower.
To Next Page
Loading...
Need help?
General
