EasyManuals Logo

Scheppach HP2500S User Manual

Scheppach HP2500S
Go to English
124 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #32 background imageLoading...
Page #32 background image
www.scheppach.com
32
|
GB
Clean the device at regular intervals using a damp
cloth and a little soft soap. Do not use any cleaning
products or solvents; they could attack the plastic parts
of the device. Make sure that no water can penetrate
the device interior.
m ATTENTION!
Never use a “pressure washer” to clean your plate
compactor. Water can penetrate tight areas of the unit
and cause damage to spindles, pulleys, bearings, or
the engine. The use of pressure washers will result in
shortened life and reduce serviceability.
11. Transport
See technical data for the weight of the machine. To
-
ing/transporting machine or storing indoors.
When changing the machine position, it can be
-

Loading the machine:
           
chain, cable or strap of adequate lifting capacity. The
unit must be transported in the upright position to pre-
vent fuel from spilling. Do not lay machine on its side
or top.

when transporting.
m Machine may fall and cause damage or injury if lifted

12. Storage
If the plate compactor will not be used for a period
longer than 30 days, follow the steps below to prepare
your unit for storage.
1. Drain the fuel tank completely. Stored fuel contain-
ing ethanol or MTBE can start to go stale in 30
days. Stale fuel has high gum content and can clog

2. Start the engine and allow it to run until it stops.
This ensures no fuel is left in the carburetor. Run
the engine until it stops. This helps prevent depos-
its from forming inside the carburetor and possible
engine damage.
3. While the engine is still warm, drain the oil from the
î™ˆî™‘î™Šî™Œî™‘î™ˆî˜‘î˜ƒî˜”î™ˆîšżî™î™î˜ƒî™šî™Œî™—î™‹î˜ƒî™‰î™•î™ˆî™–î™‹î˜ƒî™’î™Œî™î˜‘
The following points are to be observed when compact-

1. Only approach gradients from the bottom (a gra-
dient which can be easily overcome upwards can

2. The operator must never stand in the direction of
descent.
3. The max. gradient of 20° must not be exceeded
m If this gradient were exceeded, this would result
in a failure of the engine lubrication system (splash
lubrication and thus inevitably lead to a breakdown
of important engine components.
Stopping engine
To stop the engine in an emergency, simply turn the
î˜Č
conditions, use the following procedure.
1. To stop the compactor from traveling, return the

langsam schnell
vitesse lente vitesse rapide
slow fast
Pomalu rychle
PomalĂœ rĂœchly
Počasnega
hitrega
lassĂș gyors
баĐČĐœĐŸ Đ±ŃŠŃ€Đ·ĐŸ
Nopea hidas
.
2. Allow engine to cool down for one or two minutes
before stopping.
3. î˜Č
4. 󰀚
m Do not move choke control (12) to CLOSE to stop
engine. Backre or engine damage may occur.
Idle speed
Set throttle control lever to its SLOW
langsam schnell
vitesse lente vitesse rapide
slow fast
Pomalu rychle
PomalĂœ rĂœchly
Počasnega
hitrega
lassĂș gyors
баĐČĐœĐŸ Đ±ŃŠŃ€Đ·ĐŸ
Nopea hidas
position to
reduce stress on the engine when compacting is not
being performed.
Lowering the engine speed to idle the engine will help
extend the life of the engine, as well as conserve fuel
and reduce the noise level of the machine.
10. Cleaning
m ATTENTION!
Always shut the engine down and remove the spark
plug connector before carrying out any cleaning work.
We recommend that you clean the device directly after
every use.
Remove all debris from the plate compactor with a soft
brush, vacuum, or compressed air.
Clean the bottom of the compactor base as soon as it
begins to pick up soil being compacted. The unit can
not do a good job if the bottom surface is not smooth
and clean.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Scheppach HP2500S and is the answer not in the manual?

Scheppach HP2500S Specifications

General IconGeneral
BrandScheppach
ModelHP2500S
CategoryPower Tool
LanguageEnglish

Related product manuals