www.scheppach.com
36
|
GB
15. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault Possible cause Remedy
Engine fails to start.
Spark plug wire disconnected.
Attach spark plug wire securely to
spark plug.
Out of fuel or stale fuel. Fill with clean, fresh gasoline.
Throttle control lever not in
correct starting position.
Move throttle control lever to start
position.
Choke not in ON Position.
Throttle must be positioned at choke for
a cold start.
Blocked fuel line. Clean the fuel line.
Fouled spark plug. Clean, adjust gap, or replace.
Wait a few minutes to restart, but do
not prime.
Engine runs erratically.
Spark plug wire loose. Connect and tighten spark plug wire.
Unit running on CHOKE. Move choke lever to OFF.
Blocked fuel line or stale fuel.
Clean fuel line. Fill tank with clean,
fresh gasoline.
Vent plugged. Clear vent.
Water or dirt in fuel system.
Dirty air cleaner. Clean or replace air cleaner.
Engine overheats.
Dirty air cleaner. Clean air cleaner.
Remove housing and clean.
Engine will not stop when throttle
control is positioned at stop, or
engine speed does not increase
properly when throttle control is
adjusted.
Debris interfering with throttle
linkage.
Clean dirt and debris.
when pounding (machine jumps or
Too high engine speed on hard
ground.
Set the throttle lever at lower speed.
Shock absorber too loose or
damaged
Contact specialist dealer
No compacting function or the
plate compactor does not reach
the maximum speed
Damage on exciter or plate
compactor
Contact specialist dealer
Drive belt too loose and slips
on the pulley
Adjust or replace the drive belt
Oil loss from engine or exciter
Worn seal
Contact specialist dealer
Leaks on housing
To Next Page
Loading...
Need help?
General
