www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB
|
41
17. Troubleshooting
Fault Possible cause Possible cause
1. Blade dissolves
after switching off
the engine
To slightly tightened fastening nut Tighten the right hand thread nut
2. Engine will not
start
a) Failure mains fuse a) Check mains fuse
b) Defective extension cable b) Replace extension cord
c) Connections on motor or switch not
in order
c) Repair by electrical specialist
d) Motor or switch faulty d) Repair by electrical specialist
3. Motor wrong direc-
tion of rotation
a) Capacitor faulty a) Repair by electrical specialist
4. Motor will not work,
the fuse is activ
a) Cross section of the extension cable
does not suciently
a) see „Electrical connection“
b) Overload by a blunt saw blade b) Change saw blade
5. Fire marks on the
cutting surface
a) blunt saw blade a) Sharpen or change saw blade
b) wrong saw blade b) Change saw blade
To Next Page
Loading...
Need help?
General
