EasyManuals Logo

Scheppach IGT1500 User Manual

Scheppach IGT1500
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
www.scheppach.com
30
|
GB
Connection to alternating current (AC)
Allow the generator to run for a few minutes before connecting electrical devices.
Do not exceed the load capacity of the generator by connecting more electrical devices than the
device can handle.
Do not switch on electrical devices until they are connected to the generator.
Switch o󰀨 all connected electrical devices before stopping the generator.
TIP: If the generator is connected to several loads or power consumers, please remember to connect
the one with the highest starting current rst. and the one with the lowest starting current last.
Overload protection (3)
NOTE! This generator is tted with an overload protector. This cuts o󰀨 the 230V socket (7).
Switch the device o󰀨.
Reduce the total wattage of the connected electrical devices to the rated power.
Check the air lter for contamination. If contamination is detected, remove it. (see air lter)
Put the device back into operation.
Tip: The overload indicator lamp may initially light up for a few seconds when using electrical equip-
ment that requires a high starting current, such as a compressor or submersible pump. However,
this is not a malfunction.
ATTENTION! Turn the device o󰀨 immediately and contact your Service Station:
With unusual vibrations or noises.
If the engine seems overloaded or has backred.
Operation display (8)
Power indicator active - when the engine is running.
Oil warning light (12)
Display is active at low oil level and deactivated when su󰀩cient oil level.
Tip: If the engine stalls or does not start, rotate the fuel valve to “ON” and then pull the start pull cord.
If the oil warning light ickers for a few seconds, the engine oil is insu󰀩cient. Top up with oil and start
again.
9. Maintenance
Before cleaning and maintenance work, turn o󰀨 the engine and pull the spark plug connector (15)
out of the spark plug (16).
WARNING! Risk of burning! Wait until the machine has cooled down before cleaning or servicing it.
WARNING!
Take any contaminated maintenance material and operating materials to a collection point designat-
ed for this purpose.
Cleaning
Keep the safeguards, air vents and the engine housing as dust and dirt free as possible. Wipe the
device with a clean cloth or blow it with compressed air with low pressure. We recommend that you
clean the device after every use. Regularly clean the device with a damp cloth and a little soft soap.
Do not use any cleaning products or solvents which could attack the plastic part of the device. En-
sure that no water can penetrate the housing.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Scheppach IGT1500 and is the answer not in the manual?

Scheppach IGT1500 Specifications

General IconGeneral
BrandScheppach
ModelIGT1500
CategoryPortable Generator
LanguageEnglish

Related product manuals