www.scheppach.com
GB
|
25
• To prevent any imbalance, replace blunt and/or
pull the spark plug boot.
• The cutting height is centrally adjusted with the cut-
-
ent cutting heights can be selected.
• Pull the adjustor lever out and select the desired
cutting height. The lever snaps into the desired po-
Preparing the area to be mowed
Before mowing, carefully examine the area. Remove
stones, sticks, bones, wires, toys and other objects
that may be ejected.
8. Operation
m CAUTION!
The engine does not come with oil in it. There-
fore, ensure that you add 0,45 liters of oil before
starting it up. Use normal, multigrade oil (SAE30).
The oil level in the engine must be checked each
time before mowing.
You will also need to ll in petrol, as this is also
not supplied upon delivery.
• In order to avoid any unintentional start-ups of the
lawn mower, it comes equipped with an engine
before the engine can be started. When the engine
control lever is released it must return to its initial
position, at which point the engine automatically
•
Attention: When you pull the starting rope the cut-
ting blade rotates even when dissolved motor brake
lever. Make sure that there are no body parts in
danger zone of cutting blade.
• Before you start mowing, you should run through
this operation several times in order to ensure that
the machine is working properly.
m WARNING
Whenever you need to perform any kind of ad-
justment and/or repair work on your lawn mower,
wait until the blade has come to a complete stop.
Always switch o the engine before carrying out
any adjustments, maintenance or repairs.
m Note!
Using the drive:
•
When you release the lever the engine and the
blade stop automatically.
• Before you start to mow, check the start/stop lever
several times to be sure that it is working properly.
Ensure that the tension cable can be smoothly op-
• Circulatory problems in the user’s hands
• Low outside temperatures
• Extended periods of use
We therefore recommend you wear warm work gloves
and take regular breaks.
7. Before rst use
Assembling the components
Some parts of the mower come disassembled. For
quick and easy assembly, read and follow the instruc-
tions below.
Important! You will need the following additional tools
work:
•
• -
erating hours)
•
• -
•
stores)
•
stores)
•
Assembly
1. Take the mower and attachment parts out of the
packaging and check that all parts are present.
2. Attach the lower push bar to both sides of the
which will be attached later, are not in the way
3. Attach the upper push bar on the lower push bar
-
-
suring the quick-release function remains intact.
4.
hook as shown in Fig. 6.
5. Fix the cables to the push bar with the cable clips
6.
Setting the cutting height
m CAUTION!
Adjust the cutting height only when the engine is
switched o and the plug boot has been pulled.
• Before you begin to mow, check to ensure that the
blade is not blunt and that none of the fasteners are
damaged.
To Next Page
Loading...
Need help?
General
