www.scheppach.com
GB
|
31
15. Troubleshooting
Fault Possible cause Remedy
Motor does not work
Motor, cable or plug defective,
fuses burnt
Arrange for inspection of the machine by a
specialist.
Never repair the motor yourself. Danger! Check
fuses and replace if necessary
The engine runs slowly
and does not reach the
operating speed.
Voltage too low, coils damaged,
capacitor burnt
Contact the utility provider to check the voltage.
Arrange for inspection of the motor by a special-
ist. Arrange for replacement of the capacitor by
a specialist
Motor makes excessive
noise
Coils damaged, motor defective
Arrange for inspection of the motor by a spe-
cialist
The motor does not reach
its full power.
Circuits in the network are over-
loaded (lamps, other motors, etc.)
Do not use any other equipment or motors on
the same circuit
Motor overheats easily.
Overloading of the motor, insu-
cient cooling of the motor
Avoid overloading the motor, remove dust from
the motor in order to ensure optimal cooling of
the motor
To Next Page
Loading...
Need help?
General
