www.scheppach.com
GB
|
25
• The pool lter system must not be operated above
the permitted operating pressure.
• The pool lter system must not be connected to the
domestic water supply (due to overpressure).
7. Technical data
Power supply 220-240 V / 50Hz
Wattage 225 W
Maximum working pressure
of the pump
2.4 bar
Eective lter area 0,05 m²
Max. ow rate for lter
pump
11280 l/h
Greatest delivery height 5 m Hmax
Recommended lter
medium (not included in the
scope of delivery)
Quartz sand
(0.45mm-0.55mm)
Grade 20,
Filter balls
Recommended lter medi-
um quantity (circa)
Quartz sand 10 kg
Filter balls 300 g
Container volume 14 l
Protection category IPX5
Max. water temperature 43 °C
Weight 7,2 kg
Technical changes reserved!
8. Unpacking
• Open the packaging and carefully remove the de-
vice.
• Remove the packaging material, as well as the pack-
aging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the device and accessory parts for transport
damage. In the event of complaints the carrier must
be informed immediately. Later claims will not be
recognised.
• If possible, keep the packaging until the expiry of the
warranty period.
• Familiarise yourself with the product by means of the
operating instructions before using for the rst time.
• With accessories as well as wearing parts and re-
placement parts use only original parts. Replace-
ment parts can be obtained from your dealer.
• When ordering please provide our article number as
well as type and year of manufacture for your equip-
ment.
m WARNING!
The device and the packaging material are not
children’s toys! Do not let children play with plas-
tic bags, lms or small parts! There is a danger of
choking or suocating!
9. Assembly
Before installing the pool lter system, determine its
installation location. Once the lter is lled with the l-
ter medium, it is very dicult to move. The installation
surface must be absolutely even.
The location must be determined so that the suction/
skimmer line is as short as possible. If the pool is long,
for example where the skimmer is on a narrow side and
the nozzles are opposite to the narrow side, the pool
lter system must be placed on the skimmer side.
The pump should, – if possible –, be deeper than the
water surface so that it is constantly supplied with wa-
ter. If it is necessary to set up above the water level, it
must be ensured that the height dierence between the
pump and water level does not exceed 50 cm.
If the pool lter system is housed in a lter shaft, it must
be ensured that the shaft cannot be ooded. For this
purpose, it would be advisable to place an aggregate
layer (gravel) in the area of the lter shaft or to pro-
vide a direct connection into the drain or a submersible
pump with oat switch. It must be ensured that the lter
shaft is not completely air-tight as this can cause dam-
age to the pump due to the formation of condensation.
The size of the lter should be sucient so that work on
the pool lter system can be carried out.
10. Assembly
10.1 Installation of the pool lter system on the
base plate (g. 3 + 4)
1. Place the lter tank (5) in the moulded indentation
in the base plate (10).
2. Position the lter pump (11) on the base plate (10)
and screw it in place using the xing screws (21)
and the washers (22).
To Next Page
Loading...
Need help?
General