www.scheppach.com
24
|
GB
Changing the oil should take place when the engine
is warm.
WARNING! Drain fuel before replacing the oil.
Only use engine oil (15W-40).
• Always set up the device on a level and stable sur-
face. Do not operate the generator on forest soil,
which radiates heat during operation and in the
cooling phase and can ignite ammable materials!
• Remove the screws and the cover (5).
• Open the oil ller cap (17) and drain the warm engine
oil into a container by tilting the generator.
• Pour in engine oil (approx. 0.28 litres).
• Close the cover (5) and tighten the screws.
The low oil switch-o responds, if there is not enough
engine oil. The oil check bulb (12) starts to ash when
there is insucient oil in the motor. The check bulb be-
gins to ash when the oil amount has gone below the
safe level. The engine will turn o independently after
a short time. Restart is possible only after pouring in
more engine oil.
10. Storage
Preparation for storage
• Empty the petrol tank with a petrol suction pump. Re-
move fuel lter and drain the carburettor. Loosen the
screw on the lower side of the carburettor and drain
the petrol into a receptacle provided for this purpose.
Warning notice: Do not remove fuel in closed
rooms, close to re or whilst smoking. Vapours can
cause explosions or res.
• Start the engine and leave it running until the rest of
the petrol has been used up.
• Store fuel in tanks specically designed for this pur-
pose.
• Change the oil after each season. To do this, remove
the old oil from the warm engine and rell with new
oil.
• Remove the spark plug. Fill about 20 ml of oil into the
cylinder using an oil can.
• Slowly pull the express start so that the oil protects
the cylinder from the inside.
• Screw the spark plug back in
• Store the device in a well ventilated place or area.
5. Install the silencer screen (21) and the silencer cap
(20).
6. Fit the cover and tighten the screws
If the engine operates frequently in dusty or other se-
vere circumstances, clean the air lter element every
10 hours. If necessary, change the air lter element
every 25 hours. Also refer to the service information.
Clean the air lter (19) regularly, and if necessary ex-
change it.
• Open the air lter cover (18).
• Remove the lter element (19).
• When cleaning the element do not use any strong
cleaners or petrol.
• Clean the element by tapping it on a at surface. If it
is very dirty wash with soapy water, rinse with clean
water and leave to dry.
• Put it back together in the opposite order.
Spark plug (Fig. 4)
Check the spark plug after the rst 20 hours of use for
dirt and if necessary clean it with a copper wire brush.
Then service the spark plug after every 50 hours of
use.
• Remove the cover.
• Remove the spark plug connector (16) with a turning
movement.
• Remove the spark plug with the spark plug socket
(E) included.
• Put it back together in the opposite order.
Note: The petrol lter (22) is a lter bowl located directly
under the petrol cap (2) , ltering any petrol added.
1. Turn the on /o switch (10) to the “OFF“ position.
2. Open the petrol cap (2)
3. Remove the petrol lter (22) and clean in a non-
ammable solvent or solvent with a high ash
point.
4. Reinsert petrol lter (22).
5. Close the petrol cap (2).
Changing the oil (Fig. 5)
If the petrol engine operates frequently under high tem-
peratures or high loads, change the oil every 25 hours.
To Next Page
Loading...
Need help?
General
