www.scheppach.com
26
|
GB
14. Troubleshooting
Fault Possible cause Remedy
Engine does not start Automatic oil cut-out has not
responded
Check oil level, top up engine oil
Spark plug fouled Clean or replace spark plug
No fuel Refuel / have the petrol cock checked
Generator has too
little or no voltage
Electronic defective Contact your dealer
Over-current circuit-breaker
has triggered
Actuate the circuit-breaker and reduce the
consumers
Air lter dirty Clean or replace the lter
15. Maintenance schedule
Please adhere to the following maintenance periods in order to ensure a failure-free operation.
Before
each
use
After an operating
period of 20 hours
After an operating
period of 50 hours
After an oper-
ating period of
100 hours
After an oper-
ating period of
300 hours
Checking the engine oil
X
Changing the engine oil For the rst time,
then every 50
hours
X
Checking the air lter
X
Change the
lter insert if
necessary
Cleaning the air lter
X
Cleaning the petrol lter
X
Visual inspection of the
equipment
X
Cleaning the spark plug Distance: 0.6
mm, replace if
necessary
Checking andreadjusting
the throttle vale on the
carburetor
X*
Cleaning the cylinder
head
X*
Set the valve play
X*
Important: The positions marked with “x*“ should only be carried out by an authorized dealer.
To Next Page
Loading...
Need help?
General
