www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
32
|
GB
14. Troubleshooting
Problem Possible Cause Help
Saw blade gets loose
after turning off the motor
Fastening nut tightened insufciently Tighten fastening nut, right-handed thread
Motor does not start Fastening nut tightened insufciently
Extension cable defect
Connections on the motor or switch defect
Check the mains fuse.
See “Electrical Connection” in the operating
manual
Have it checked by an electrician
Motor has wrong direc-
tion of rotation
Defective capacitor
Wrong connected
Check by qualied electrician
Exchange the polarity of the wall socket by
qualied electrician
Engine does not provide
power,the fuse triggers
Cross-section of the extension line is not
sufcient
Overload by blunt saw blade
see Electrical connection
Change saw blade
Burns on the cutting
surface with longitudinal
cuts with cross cuts
Wrong saw blade
Longitudinal stop not parallel
Slide carriage not parallel
Insert a sharpened saw blade
Insert saw blade with 20 or 28 teeth for longi-
tudinal cuts
Exchange the longitudinal stop
To Next Page
Loading...
Need help?
General