Compliance Statement and Safety Issues
FCC Compliance Statement
Changes or modifications not expressly approved by Schick Technologies could void
your authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) This device
must accept any interference received, including interference that may cause undesired
operation.
Check CDR Wireless Sensor before Using It
Before each usage, check the CDR Wireless Sensor for any signs of physical damage or
defect. Make sure the battery pack is attached securely to the sensor. Before taking X-
rays, observe the proper guidelines for using sheaths, holders, and tabs.
Observe Handling, Storage, and Disposal Guidelines for
Batteries
Your CDR Wireless Sensor system is equipped with disposable batteries that have been
packaged and protected at the factory. Be sure to read the special instructions relating to
battery usage and follow all of the guidelines for storage and disposal.
Radio Frequency (RF) Interference Considerations
Your CDR Wireless Sensor system has been tested and found to comply with the limits
for a Class A digital device under the Federal Communication Commission's Rules and
Regulations. These limits are designed to provide reasonable protection against harmful
interference when the system is operated in a commercial (in this case, clinical)
environment. To operate this system safely, follow all the procedures in accordance with
this User Guide and all other documentation distributed with this system.
CDR Wireless User Guide B1051301 Rev. - (DRAFT)
iii
To Next Page
Loading...