Schiit LYR+ - GETTING STARTED; No Tube Operation; Tube Installation and Operation; Tube Replacement

012345678
115VAC 30W
ASSY IN USA
VOLUME
INPUT PREOUT
MUTE
GAIN
MODE
5 Gain/Mode Select. Push this button to toggle
between low and high gain modes. When chang-
ing gain, the gain light will ash briey
If you don’t have the remote handy, you can
also press and hold the Gain/Mode switch for
4 seconds or more to change operating modes.
When you release the button, the mode light
will ash for up to 40 seconds during the mode
change.
6 Headphone Jack. Plug your headphones in
here, using a standard 1/4” TRS plug.
1 Input Select. Press this button to toggle be-
tween the two inputs. To the right of the button,
the selected input lights up.
2 Preamp Output Enable. Push the button to en-
able and disable the preamp output. The light to
the right indicates when the preamp outs are on.
3 Volume Control. Turn up till the music sounds
good, but before your ears turn to taffy.
4 Mode Indicator. When this light is on, Lyr+ is
using its internal solid-state gain stage. When it’s
off, then it’s running tube gain. Remember, you
can’t run tube gain without a tube!
1 Input. Press this button to select the input you want to
listen to. If you skip the input, keep pressing—it cycles back
around.
2 Tube/MOSFET Mode. When you have a tube installed, you
can switch back and forth between tube and MOSFET gain
modes by pressing this button. The Mode light will ash for
up to 40 seconds while changing modes.If you don’t have a
tube installed, this button won’t do anything.
3 Gain. Toggle between low and high gain with this button.
The Gain light will ash briey when changing modes. We
recommend turning down the volume before switching to
high gain, as it is signicantly higher than low gain.
4 Mute. Press to mute Lyr+—headphone, preamp outs,
everything goes off.
5 Preamp Output Enable/Disable. Press to enable or disable
the preamp outputs.
6 Volume Up/Down. Press the up arrow to turn volume up,
press the down arrow to turn it down. Simple!
Note: To change the remote battery, push the front off the remote using a
paperclip through the back hole, then replace with the same size and type.
REMOTE CONTROLCONTROLS
012345678
115VAC 30W
ASSY IN USA
VOLUME
INPUT PREOUT
MUTE
GAIN
MODE
1 2
3
4
5
6
1
2
3
4
5
6