Do you have a question about the Schiit Modi 3 and is the answer not in the manual?
Connect the two RCA jacks to your amp, preamp, or receiver.
Connect a coaxial digital source using a 75 ohm RCA cable.
Connect an optical source using a Toslink cable.
Connect a USB source using the supplied USB micro cable.
Connect a 5V power source for external power if needed.
Explains using Modi 3 with USB or other digital inputs and required power.
Indicator light that shows when the Modi 3 is powered on.
Toggle switch to choose between USB, Optical, and Coaxial inputs.
Fixes for 'Draws too much power' errors using external power.
Ensures correct selection in system settings and mentions driver needs.
Details warranty terms, limitations, and service contact information.
Lists the items included in the product packaging.
| DAC Chip | AKM AK4490 |
|---|---|
| Inputs | USB, Optical, Coaxial |
| Outputs | RCA |
| Output Impedance | 75 ohms |
| Frequency Response | 20Hz-20kHz, +/-0.1dB |
| Maximum Output | 2.0Vrms |
| Dimensions | 5 x 3.5 x 1.25 inches |
| Supported Sample Rates | 16/44.1 to 24/192 |
| Bit Depth | 16-bit, 24-bit |
| Dynamic Range | >115dB |
| Power Supply | USB powered |
| SNR | >115dB, A-weighted, referenced to full output |
Loading...