I hear hum, what do I do?
You may have too much gain in the system,
or have a ground loop in other connected
gear. Try low gain, and if that doesn’t work,
check for ground loops in the rest of the
system.
There’s no sound after I turn Saga 2 on.
Saga 2 delays the output for 40 seconds
after you rst turn the preamp on for self-
checks, during which time the LEDs ash.
No, I mean there’s still no sound?
Is the preamp muted? If none of the input
LEDs is lit, the preamp is muted. Unmute
using the remote. If the problem persists
after that, make sure you have the right
input selected.
What’s with the clicking noises when I turn
the volume?
That’s the sound of the mechanical relays
in the relay-switched stepped attenuator.
Totally normal.
FAQ
It seems like it drops out when I’m
adjusting volume?
We have adjusted relay timing for minimal
transients, so there may be some muting
while adjusting volume. Once you stop
adjusting, it will be ne.
Does Saga 2 convert from SE to balanced?
If you are using the Low or High gain
settings, yes. Passive cannot convert.
Can I use both balanced and SE outputs at
the same time?
Most of the time, yes. If you have products
that short the input when turned off, then
that can cause distortion.
I have the volume all the way down and still
hear faint music.
Yes, that is normal with a relay attenuator.
If it’s bothersome, hit the Mute button to
completely mute the preamp.
It doesn’t turn on, what do I do?
Plug it in to a different AC socket. Ensure
you are not currently in a blackout. Then
email us if it still doesn’t work.
To Next Page
Loading...
